Detection efficiency & acceptance
The fraction of true signal events that pass triggering, reconstruction and selection.
Efficiency depends on energy, position and event type and is estimated with simulation validated by calibration. Acceptance covers geometric or kinematic coverage. Uncertainties on efficiency often enter as normalisation systematics.
In plain words
Not every neutrino that interacts in a detector ends up in the final data set. The light may be too faint to trigger the electronics, the event may be reconstructed in the wrong place, or a selection cut meant to remove background may remove it too. Efficiency is the fraction that survives this chain. Acceptance is the related question of whether the detector could have seen the event at all, given its geometry and energy threshold.
In detail
Efficiencies are estimated with Monte Carlo simulation of the detector, then checked against calibration sources and control samples with known properties. The difference between simulation and calibration becomes a systematic uncertainty. Neutrino telescopes combine efficiency, target mass and cross section into a single 'effective area', which grows steeply with energy.
Examples
- Homestake: Raymond Davis Jr. added a known amount of a different argon isotope to each run to measure how efficiently argon was extracted from the tank.
- Gallium experiments exposed their targets to intense ⁵¹Cr and ³⁷Ar sources to test the whole chain from capture to counting. The measured rates came out lower than expected, the origin of the gallium anomaly.
- Super-Kamiokande dissolved gadolinium in its water. At about 0.01% gadolinium, around half of the neutrons from inverse beta decay are captured on gadolinium; at 0.03% about three quarters, improving neutron tagging markedly.
- Low-energy experiments lose efficiency near the energy threshold, where trigger and reconstruction become uncertain.
Why it matters
An error in efficiency looks exactly like a change in flux or cross section, so it enters as a normalisation systematic uncertainty. Near and far detectors built identically, as at Daya Bay, cancel most of it in the ratio.
Frequently asked questions
Is a higher efficiency always better?
Not always. Looser cuts raise efficiency but let in more background. Analyses optimise the balance, often by maximising expected sensitivity rather than efficiency alone.
How can efficiency be measured if the true events are unknown?
With artificial sources of known strength, with simulated events validated on calibration data, and with control samples such as cosmic muons or decay electrons whose properties are well understood.
Related terms
Mentioned in 8 pages
Last updated: · Editorial standard
Cite this page
Text
Neutrino Atlas (2026). “Detection efficiency & acceptance”. Retrieved 22 November 2026, from https://neutrino-atlas.com/terms/efficiency/BibTeX
@misc{neutrinoatlas2026termsefficiency,
title = {Detection efficiency & acceptance},
author = {{Neutrino Atlas}},
year = {2026},
url = {https://neutrino-atlas.com/terms/efficiency/},
note = {Accessed 2026-11-22},
language = {english}
}