Neutrino Atlas
EN
  1. Terms
  2. Analysis & measurement
  3. Oscillation observables
  4. Rate vs shape analysis

Rate vs shape analysis

ConceptLevel 3 of 4

Using either the total event count or the distortion of the energy spectrum to measure oscillation.

Rate-only analyses depend on absolute flux normalisation. Shape analyses compare spectra and are robust against normalisation errors but sensitive to energy-scale uncertainties. Most modern results combine both (rate + shape).

In plain words

There are two ways to notice that some neutrinos have gone missing. You can count them and find fewer than expected – a rate measurement. Or you can look at how the missing ones are distributed across energies – a shape measurement. Oscillation removes neutrinos selectively, depending on L/E, so it leaves a characteristic dent in the energy spectrum. The count tells you how much is missing; the shape tells you where.

In detail

A rate-only analysis compares the observed number of events with the prediction. Its weakness is normalisation: the absolute flux, the number of target protons, the detection efficiency and the cross section all enter directly. A shape-only analysis normalises the spectrum and asks only whether its form has changed. It is immune to overall normalisation errors but sensitive to the energy scale and energy resolution, because a miscalibrated energy axis can mimic or hide a distortion. A rate+shape fit uses both and usually gives the best result. The amplitude of oscillation, related to sin²2θ, is mostly constrained by the rate; the frequency, set by Δm², mostly by the shape.

Examples

  • KamLAND's first result in 2002 was essentially a rate measurement: the ratio of observed to expected reactor antineutrinos was 0.611 ± 0.085 (stat) ± 0.041 (syst). Later data added the spectral distortion and measured Δm²₂₁ precisely.
  • Daya Bay's 2012 discovery of θ₁₃ used a rate-only near–far comparison. Later Daya Bay analyses used the shape of the far/near spectral ratio to measure Δm²ee as well.
  • The reactor antineutrino anomaly is a rate effect, a deficit of about 6 percent relative to flux predictions. The 5 MeV bump is a shape effect, an excess near 5 MeV seen at Daya Bay, RENO and Double Chooz. Near–far comparisons showed that neither is caused by oscillation.

Why it matters for neutrino physics

The distinction explains why experiments that agree on physics can differ in their dominant uncertainties. Sterile-neutrino searches at very short baselines, such as PROSPECT and STEREO, rely on shape comparisons between detector segments at different distances, precisely so that their conclusions do not depend on the uncertain absolute reactor flux models.

Frequently asked questions

Is a shape analysis always better than a rate analysis?

No. A shape analysis has no sensitivity when the oscillation is so fast that it averages out, or so slow that it barely changes across the measured range. It also depends strongly on the energy calibration.

Why did the 5 MeV bump not affect the θ₁₃ measurement?

θ₁₃ was extracted from the comparison of near and far detectors. A feature already present in the reactor spectrum appears equally at both sites and cancels.

Related terms

People

On the timeline

  1. 2004KamLAND observes the oscillation spectrum

Mentioned in 5 pages

Last updated: · Editorial standard

Cite this page

Text

Neutrino Atlas (2026). “Rate vs shape analysis”. Retrieved 22 November 2026, from https://neutrino-atlas.com/terms/rate-vs-shape/

BibTeX

@misc{neutrinoatlas2026termsratevsshape,
  title        = {Rate vs shape analysis},
  author       = {{Neutrino Atlas}},
  year         = {2026},
  url          = {https://neutrino-atlas.com/terms/rate-vs-shape/},
  note         = {Accessed 2026-11-22},
  language     = {english}
}