Neutrino Atlas
EN
  1. History of the neutrino
  2. The oscillation era
  3. 2012

2012Discovery

RENO confirms θ₁₃

Confirmed

On 3 April 2012 the Reactor Experiment for Neutrino Oscillation at the Hanbit (Yonggwang) plant in South Korea, led by Soo-Bong Kim, reported a 4.9σ observation of electron antineutrino disappearance with identical near and far detectors. Its value, sin²2θ₁₃ = 0.113 ± 0.023, independently confirmed Daya Bay within weeks. θ₁₃ became the most precisely measured mixing angle within a few years.

The Yonggwang (Hanbit) nuclear power plant in Korea
The Hanbit (formerly Yonggwang) power plant in Korea, whose reactors RENO used to measure θ_13 in 2012.Image: IAEA Imagebank · Public domain · commons.wikimedia.org
Date
3 April 2012
Kind of event
Discovery
People involved
Soo-Bong Kim
Experiments
RENO

The situation before

By 2011 two of the three neutrino mixing angles were well measured, but the third, θ13, was still only bounded from above. The CHOOZ reactor experiment had shown in the late 1990s that it had to be small, and some theorists suspected it might be exactly zero. That mattered: a vanishing θ13 would make leptonic CP violation unobservable in oscillations. In 2011 T2K and MINOS saw first hints of electron-neutrino appearance, and Double Chooz reported a reactor deficit at low significance. Three new reactor experiments with near and far detectors were racing to settle the question: Double Chooz in France, Daya Bay in China and RENO in South Korea.

What happened

RENO was built at the Yonggwang nuclear power plant (today Hanbit) on the west coast of Korea, with six reactors in a line producing about 16.4 GW of thermal power. The collaboration, led by Soo-Bong Kim of Seoul National University, placed two identical detectors, each with 16 tonnes of gadolinium-loaded liquid scintillator, at about 290 m and 1,380 m from the centre of the reactor array. Both counted reactor antineutrinos through inverse beta decay. Because the two detectors were identical, most uncertainties about the reactor flux and the detector response cancelled in the ratio.

Data taking with both detectors began in August 2011. On 8 March 2012 Daya Bay announced a 5.2σ observation of a non-zero θ13. Less than four weeks later, on 3 April 2012, RENO presented its own result from 229 days of data at a seminar in Seoul and posted it on arXiv. The far detector saw about 8 percent fewer antineutrinos than expected from the near detector: the observed-to-expected ratio was 0.920 ± 0.009 (stat.) ± 0.014 (syst.). A rate-only analysis gave

sin²2θ13 = 0.113 ± 0.013 (stat.) ± 0.019 (syst.)RENO, Physical Review Letters 108, 191802 (2012)

The significance of a non-zero value was 4.9σ. The paper appeared in Physical Review Letters in May 2012.

Reaction

Within one month two independent experiments, at different reactors, with different teams and analysis methods, had found the same effect. The RENO value was somewhat larger than Daya Bay's 0.092 but consistent within the uncertainties. Together with the earlier hints from T2K, MINOS and Double Chooz, the community accepted the non-zero θ13 as established almost immediately. Global fits from mid-2012 already treated it as a measured parameter rather than a limit.

Why it matters

θ13 turned out to be about 8.5 to 9 degrees, not tiny. This was good news for the whole field: the size of θ13 sets the strength of the electron-neutrino appearance signal in which δCP and the mass ordering show up. The large value made the CP programme of T2K and NOvA, and later of DUNE and Hyper-Kamiokande, realistic. It also enabled JUNO's plan to determine the mass ordering with reactor neutrinos.

RENO kept running for years and improved its own precision. In 2014 it also helped draw attention to an unexpected excess of reactor antineutrinos near 5 MeV in the energy spectrum, the so-called five-MeV bump, seen by Daya Bay and Double Chooz as well. Daya Bay's final result in 2022, sin²2θ13 ≈ 0.085 with about 3 percent precision, made θ13 the best-measured mixing angle.

Frequently asked questions

When was θ13 measured for the first time?

Daya Bay announced the first 5σ observation on 8 March 2012. RENO followed with an independent 4.9σ result on 3 April 2012. Earlier hints had come from T2K, MINOS and Double Chooz in 2011.

Why did RENO use two identical detectors?

Comparing a near and a far detector of the same design cancels most uncertainties about how many antineutrinos the reactors emit and how efficiently they are detected. Only the oscillation-induced deficit at the far site remains.

Why was a non-zero θ13 important?

Without θ13 the electron-neutrino appearance channel would be almost closed, and CP violation and the mass ordering could not be measured in oscillation experiments. Its fairly large value made the next generation of long-baseline experiments possible.

Original papers

  1. DiscoveryJ. K. Ahn et al. (RENO Collaboration), Observation of Reactor Electron Antineutrinos Disappearance in the RENO Experiment, Phys. Rev. Lett. 108, 191802 (2012)DOI 10.1103/PhysRevLett.108.191802

Concepts

Mentioned in 1 page

Last updated: · Editorial standard

Cite this page

Text

Neutrino Atlas (2026). “2012: RENO confirms θ₁₃”. Retrieved 22 November 2026, from https://neutrino-atlas.com/timeline/2012-reno-theta13/

BibTeX

@misc{neutrinoatlas2026timeline2012renotheta13,
  title        = {2012: RENO confirms θ₁₃},
  author       = {{Neutrino Atlas}},
  year         = {2026},
  url          = {https://neutrino-atlas.com/timeline/2012-reno-theta13/},
  note         = {Accessed 2026-11-22},
  language     = {english}
}

Back to the timeline